Although Whirlpool baths are luxurious and relaxing, they can sometimes malfunction like other things. This guide shall guide you on how to troubleshoot some common issues you might be experiencing with your Whirlpool bathtub.
Lacking of Jet Functions
Ensure the power source of your Whirlpool bathtub has not been tripped for your jets not to function. Check whether the electrical breaker hasn't tripped, and the bathtub is rightly connected. If the electricity is working fine, then the pump might be the culprit. Listen for any unusual noises from the pump since they can indicate a blockage or an issue. If the pump seems to be working but the jets are not, then there could be debris clogging the jet nozzles. Turn off the power supply and clean the jets with a soft brush removing any debris that can be seen.
Water Heating Issues
Whirlpool bath water usually isn’t heated to the right level. This problem can be related to the heating element. Verify the setting on the thermostat to ensure it is set appropriately. If the water is still cold, it could be necessary to replace the heater element. Before replacing the heater, make sure the power connection is tight. If you’re not comfortable handling electrical components, get help from a professional.
Low Water Pressure Adjustments
Any drop in the water pressure from the jets which you can see, is likely due to a clogged filter. The water flowing through the filter can be reduced over time, by the accumulation of dirt and debris. Switch off your bathtub, locate the filter (usually near the pump), and clean or replace it as needed to correct this. Regular maintenance of filters can prevent this from reoccurring.
Noisy Function
Air in the pipes or a loose part may be responsible for noisy Whirlpool baths sometimes. Ensure that the water level is high enough to cover the jets before activating the system for the solution of this. If the noise persists, look around the pump for loose components or fittings and motor. Often, loosening these components can fix the problem.
Unpleasant Odors
Bad smells coming from your Whirlpool bathtub may be the result of bacterial development in the pipes. To disinfect the system, run a mixture of water and a cleaning solution through the jets (such as white vinegar or a specialty tub cleaner). Odor development can be halted with routine cleaning.
Final Thoughts
Since Whirlpool bathtubs are designed to be stress-free areas, it is of utmost importance to quickly settle any issues that may come up. Most problems can be prevented with regular maintenance, which involves checking the electrical connections, cleaning the jets and filters, and ensuring the water level is accurate. Never hesitate to ask for professional assistance if you cannot handle a problem on your own.
FAQs
Q: What is causing my whirlpool bathtub's jets to malfunction?
A: Ensure the electric breaker hasn't been tripped and that the power is turned on. Clean off debris from the nozzles if the pump is running but the jets are not working. Pay attention to unusual sounds since they may be telling you of blockages or malfunctioning pumps.
Q: The water in my Whirlpool bathtub does not heat properly. What should I do?
A: Ensure that the power connections are tight and inspect the thermostat settings. It might be required to replace the heating element if the water does not warm up. If you're not sure how to handle electrical components, seek professional help.
Q: What is causing the noise in my whirlpool bathtub?
A: Air in pipes or loose parts can cause the noises. Before turning it on, ensure that all jets are fully submerged in water. Check for loose parts or fittings on the pump and tighten them.
